Plating International Inc.’ s new video discusses why Bob the chrome plater is ready to make the switch to a Flex Kraft switch mode rectifier from his traditional SCR rectifier. Click the video below to learn more!

Good things come in small packages; that’s why our FlexKraft rectifiers give you the most bang-for-buck. FlexKraft is the best choice if you want to lower your costs without sacrificing efficiency. The compact units are serviced from the front, which saves a lot of time and keeps any potential down-time to a minimum. They can be place side- by-side or stacked making them optimal for spacing. Above all, they are easy to install and maintain.

Each rectifier has up to ten modules and two or more stacks can be connected to allow higher currents (24 kA) and voltages (120 V DC). Thanks to the modular design you only pay for the power you need. Should you need more power later on - simply add more modules.

Other great benefits of the FlexKraft design:

• Tough, robust, and reliable - very durable for use in harsh conditions of plating shops

• Protected from short circuits and excessive temperatures

• Very Low-Ripple

• Efficiency above 90%

• At any given load, power factor is +93%

• Designed for 24 hour operation at maximum load (40 degrees)

• Available in single or dual output; plating power up to 24,000 Amps

• Can run on reduced power if a fault occurs in a module

• Independent settings for currents and voltage

Check out our Products Page to read more information on Plating International’s rectifiers or any one of the great products we offer. Contact us today for a quote!